Replacement of bearing assemblies in axial gearboxes avtotris
Abstract
The kinematic scheme of the hydro-mechanical transmission UGP-230 of the diesel assembly ADM-1 is considered.3. The loads affecting the bearing units of the axial gearbox, which have a negative impact on the performance of not only the bearings, but also the entire unit, have been identified. The replacement of tapered roller bearings with bearings with a long service life is proposed.
About the Authors
V. A. Krutova
Rostov State Transport University (RSTU)
Russian Federation
Russian Federation
Krutova Veronika Aleksandrovna, Chair “Machine Design Fundamentals”, Candidate of Engineering Sciences, Associate Professor
K. A. Fedotov
Rostov State Transport University (RSTU)
Russian Federation
Russian Federation
Fedotov Kirill Andreevich, Chair “Machine Design Fundamentals”, Postgraduate student
References
1. Radkevich, Ya. M. Metrology, standardization and certification : textbook / Ya. M. Radkevich, A. G. Skhirtladze, B. I. Laktionov. – 2nd ed. – Saratov : University Education, 2019. – 791 p. – ISBN 978-5-4487-0335-5.
2. Zhukov, V. K. Metrology. Measurement theory : a textbook for universities / V. K. Zhukov. – Moscow : Yurayt Publishing House, 2020. – 414 p. – ISBN 978-5-534-03865-1.
3. Bondarenko, V. A. Modeling of noise generation in the case of gearboxes of increased power during vibration isolation of bearing units / V. A. Bondarenko, A. N. Chukarin // Vestnik Rostovskogo Gosudarstvennogo Universiteta Putey Soobshcheniya. – 2013. – No. 1 (49). – P. 7–11. – ISSN 0201-727Х.
Review
For citations:
Krutova V.A., Fedotov K.A. Replacement of bearing assemblies in axial gearboxes avtotris. Trudy Rostovskogo gosudarstvennogo universiteta putey soobseniya. 2023;(3):67-71. (In Russ.)
Views:
45
JATS XML
Email this article 